Remove large chips on the inside of the work area door from top to bottom. Use
a chip hook for this purpose.
2.
Example: 2 Sweep small chips and other debris from top to bottom using chip brooms or brushes.
Remove small chips and chip accumulations on the inside of the work area
door from top to bottom. Use a chip brush for this purpose.
3. Clean the area behind the wipers.
4.
Example: 3 upper wipers, G300
Replace wipers.
5.
Make sure that the wipers evenly contact the work area door,
before tightening the screws.
Maintenance Summary - 4.000 Operating hours
100
Maintenance Instructions
C200
LP1702.10021 - 05.06.2019
To Next Page
Loading...
