C540 - Check cable and hose clamps for tight seating
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must only be carried out by staff that has received adequate training
by the machine manufacturer!
Orientation
Cable and hose clamps are used to bundle and/or hold the cables and hoses in a
certain position.
Loose or faulty clamps can be abrasive to cables or hoses and damage them. Under
unfavorable circumstances, defective clamps may lead to “entangling” of the cables/
hoses, which may result in tearing off entire bundles.
Procedure
1. Check cables for chafing and kinks.
2. Check cable and hose clamps for tight seating. In case of moving drags or
bundles, check for any movement within the function.
3.
Example: Power cabling, G400
Check strain relief. Check the correct position of the boots and adjust the strain
reliefs.
4. Record any damages and initiate repair.
Maintenance Summary - 2.000 Operating hours
65
Maintenance Instructions
C200
LP1702.10021 - 05.06.2019
To Next Page
Loading...
