D540 - Check motor protection switch setting and load tap
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must only be carried out by staff that has received adequate training
by the machine manufacturer!
Orientation
This check must be carried out on all motors that have a motor protection.
Obtain the motor rated current from the nameplate or from the circuit diagrams.
Requirement
Observe the specific electrical diagrams for this machine.
Procedure
1. Check the motor protection switch setting.
2. Check consumer tap
Maintenance Summary - 4.000 Operating hours
105
Maintenance Instructions
C200
LP1702.10021 - 05.06.2019
To Next Page
Loading...
