J050 - Replacing the viewing glass
Orientation
If the viewing glass is damaged, it must be replaced. This is
necessary regardless of the extent of damage. Even with minimal
damage, the impact resistance of the glass can no longer be
guaranteed.
For safety reasons, it is recommended to obtain the viewing glass
directly from the machine manufacturer or its country representative.
The viewing glass consists of three panes. the inner pane of tempered glass, the
central pane of polycarbonate, and the outer pane also made of polycarbonate. The
inner pane is relatively resistant. It can be cleaned with any commercially available
cleaning agents. Only the center pane is essential for the impact resistance of the
viewing glass. The polycarbonate panes are subject to natural aging and must be
replaced at regular intervals.
Procedure
1. Replace the viewing glass.
Maintenance Summary - 8 Years
123
Maintenance Instructions
C200
LP1702.10021 - 05.06.2019
To Next Page
Loading...
