2.
Clean the outer pane with a soft cloth or sponge and glass
cleaner or soap and water. Do not use abrasive or alkaline
cleaners (e.g., benzene, acetone or carbon tetrachloride) and
no sharp tools or sharp objects (such as razor blades or
screwdrivers).
Clean outer pane.
3. Clean inner pane.
4.
Example: Safety label - viewing glass 2006
1
Year of manufacture
2 Protection class and EN standard
3 Manufacturer
4 INDEX part number
Check safety label. (Replacement interval every 8 years)
5. Check wipers. Remove and clean the wipers. If the wipers are severely
deformed or damaged, they must be replaced. To be able to clean the door
panels evenly, be sure to reinstall the wipers after their removal aligned in
parallel and ensure that they snugly contact the work area door.
6. Check the work area door for ease of movement. To do so, open and close the
work area door. If the work area door can be moved only with elevated effort
(drive motor), determine the cause. Possible causes are defective or
improperly adjusted wipers, or chips on the guide bar or in the guide rollers of
the work area door.
7.
Danger
Pinching of limbs due to faulty safety shutdown on the
work area door
Check safety shutdown.
Use only appropriate tools such as a broom handle, wooden
beams or similar for checking.
Maintenance Summary - 2.000 Operating hours
46
Maintenance Instructions
C200
LP1702.10021 - 05.06.2019
To Next Page
Loading...
