C090 - Replace wiper of counter spindle guide in the work area
Orientation
Due to their open-access location, the counter spindle wipers may be contaminated
or impaired by chips particularly hard. Therefore, special attention should be given
to the condition of the wipers during servicing and maintenance activities.
Procedure
1.
Example: wiper (1) counter spindle C100/C200
Bring counter spindle into working position.
2.
Caution
Uncontrolled movements of tool carriers or accessories.
Cuts and crush injuries to hands and arms.
Trigger an EMERGENCY STOP on the machine or switch off the
machine completely
Check wipers.
Alternatively, the following procedure can be used!
Replace wipers, if necessary.
3. Unscrew defective wiper and push to the left of the guide bar. Be sure to
clean the space behind the wiper before inserting the new wiper.
Cleaning is essential, otherwise the wiper will again be damaged in the
first movement of the counter spindle and the durability of the new
wiper will be significantly reduced.
4. Oil cleaned guide bar so that the wiper can easily be pushed over the guide
bar. Slide new wiper carefully onto the guide bar.
5. Slide wiper again to the right up to the contact surface and fasten with the 2x
M4 screws. When securing the new wiper, make sure that the wiper
evenly contacts the contour of the bar.
Maintenance Summary - 2.000 Operating hours
56
Maintenance Instructions
C200
LP1702.10021 - 05.06.2019
To Next Page
