Page 24
Copyright© 2019 Ingenico
Supervisor Functions
Supervisor code
Default supervisor code is 01483
The Supervisor code is designed to limit access to the Supervisor functions
(such as the Supervisor Menus, or Refund transactions) on the terminal to those
who have access to the code.
Your terminal is shipped with an initial default code of 01483, but is configured
so that a change of this code is required before you process any transactions. If
you forget your code, please contact the terminal Helpdesk who will be able to
reset the code back to the default.
The following codes are not valid choices for your Supervisor
code: 01483, 1234, 0000, or 9999.
Any other numerical code of four or more digits will be a valid
Supervisor code.
The Supervisor code allows entry into the Refund option on the
terminal.
To change your Supervisor code press the function button twice, then
choose SUPERVISOR from the list. You will be asked to type your current
supervisor code (i.e. 01483), then press button, choose PASSWORD then
CHANGE PWD.
You will need to enter your new numerical code (4 digits or more) twice,
pressing the button after each input, before the Supervisor code is updated
to this new value.
If your terminal is lost or stolen you should contact the terminal
Helpdesk immediately.
To Next Page
Loading...
Need help?
General
