27
Version 2.02 December-2002
4.2) To Control an Auxiliary Output:
a) Select Auxiliary Control Mode: Press <9>, then 24 (Auxiliary Control & Test Mode)
b) Toggle the Auxiliary On or Off: Press <Auxiliary Number>, <#>
e.g. To Turn Auxiliary 3 On. Press: 3, <#>.
c) Logout of Aux Control Mode: Press <*>. (If this is not done before hanging up, you must wait
at least 30 seconds before calling the system again)
The Control Module will then reply with a Status message:
- A series of Beeps of the same tone to indicate Auxiliary On.
- A series of Beeps of 2 different tones to indicate Auxiliary Off.
- A series of Beeps of 8 different tones to indicate the operation could not be performed.
4.3) To Isolate a Zone Input:
a) Select Zone Isolate Mode: Press <9>, then 21 (Zone Isolate Mode)
b) Toggle the Zone Isolated/De-Isolated: Press <Zone Number>, <#>
e.g. To change the Status of Zone 6. Press: 6, <#>.
c) Logout of Zone Isolate Mode: Press <*>. (If this is not done before hanging up, you must wait
at least 30 seconds before calling the system again)
The Control Module will then reply with a Status message:
- A series of Beeps of the same tone to indicate Zone Isolated.
- A series of Beeps of 2 different tones to indicate Zone De-isolated.
- A series of Beeps of 8 different tones to indicate the operation could not be performed.
4.4) To Control User Auxiliary A or B:
a) At Step 3, simply Key in the User Auxiliary A PIN Code, or the User Auxiliary B PIN Code.
This will Toggle the state of the Auxiliary.
The Control Module will then reply with a Status message:
- A series of Beeps of the same tone to indicate Auxiliary On.
- A series of Beeps of 2 different tones to indicate Auxiliary Off.
- A series of Beeps of 8 different tones to indicate the operation could not be performed.
NOTE: There is a 2 minute delay required between dial-in attempts. This enhances protection against
unauthorized access into the system. Once you have hung-up the Telephone following a Telephone remote
control operation, please wait at least 2 minutes before attempting to connect again.
REMOTE CONTROL
To Next Page
Loading...
Need help?
General
