28
Version 2.02 December-2002
6. Wireless Remote Control
Your system may be equipped with up to six 4-Button, RF Wireless Remote Control KeyFobs.
(Wireless Remote Control is an optional feature and requires an Inner Range RF Receiver and an Enhanced
RF LED Terminal or RF Module to be connected to the system)
REMOTE CONTROL KEYFOB FUNCTIONS:
The following Remote Control functions are available:
1) [ ] ARM and DISARM the Alarm system.
[ ] OR; ARM & DISARM all the Areas in the User’s Area List. (If used in a Multi-Area system)
2) [ ] HOME ARM and DISARM the Alarm system.
[ ] OR; HOME ARM & DISARM all the Areas in the User’s Area List. (If used in Multi-Area system)
2) [ ] Turn an AUXILIARY OUTPUT On and Off.
3) [ ] Activate a PANIC ALARM by pressing the Arm/Disarm keys simultaneously.
You may wish to use the check-boxes above to indicate which of these functions have been enabled in your
system by the Installer.
OPERATION:
To ARM or DISARM the System:
To Arm: Press the < • > key.
To Disarm: Press the < : > key.
The Area status can be checked on an LED Terminal.
To HOME ARM the System:
To Home Arm: Press the < 1 > key.
To Control the AUXILIARY OUTPUT*:
To Trigger: Press the < 2 > key.
To Activate the PANIC ALARM:
Press the < 1 > and < 2 > keys AT THE SAME TIME.
* AUXILIARY CONTROL. Consult with your Installer regarding
the Auxiliary action required.
To Next Page
Loading...
Need help?
General
