EasyManuals Logo

Inner Range CONCEPT IQ User Manual

Inner Range CONCEPT IQ
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
Version 2.02 December-2002
The Call Divert option enables the Concept IQ system to dial your Call Divert number when the
system is fully Armed and dial your Call Un-divert number when the system is Disarmed.
This provides a convenient method of automatically diverting incoming telephone calls to another
telephone number (e.g a mobile phone) when the premises is unoccupied.
Your telephone service provider can provide details of the Call Divert/Un-divert numbers for your
telephone service. Note that this facility may incur an additional cost on your telephone service.
1. Enter the Call Divert Telephone Number programming Mode.
Enter your PIN code; ... , then press , , .
The <A1> Lamp will flash to indicate the system is ready for the Call Divert Telephone Number entry.
2. View the Call Divert Telephone Number.
If a Call Divert Telephone Number is already programmed, the digits of the current number will be
displayed sequentially via the Zone Lamps and the “0” Lamp. A chirp will sound each time the
display steps to the next digit.
When the end of the Telephone number is reached, 3 short beeps will sound to indicate there are no
more digits to display.
3. Program the Call Divert Telephone number.
The display will prompt for each digit to be entered via flashing Zone Lamps.
Enter the new Telephone number ... (Up to 15 digits), then press .
The digits are entered according to the following table.
Telephone number digit to program: 0 to 9 * # Pause (4 Second)
Key/s to Press on keypad: 0 to 9 OFF, 1, 0 OFF, 1, 1 OFF, 1, 2
Value displayed on Zone Lamps: 0 to 9 10 11 12
e.g. Telephone number: * 21 1234 5678 # is entered by the key sequence:
<OFF>, 1, 0, 2, 1, 1, 2, 3, 4, 5, 6, 7, 8, <OFF>, 1, 1, <ENTER>
If a mistake is made while keying in the Telephone number digits, press to clear all the digits
entered and start keying in the number again.
3 beeps will sound to confirm the new Telephone number has been programmed.
If the Telephone number was rejected, one long beep will sound to indicate a problem.
4.9 PROGRAM OR VIEW THE CALL DIVERT NUMBERS. NEXT 32

Other manuals for Inner Range CONCEPT IQ

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Inner Range CONCEPT IQ and is the answer not in the manual?

Inner Range CONCEPT IQ Specifications

General IconGeneral
BrandInner Range
ModelCONCEPT IQ
CategorySecurity System
LanguageEnglish

Related product manuals