21
Version 2.02 December-2002
4. View the Secondary Telephone number. (If programmed)
When the Primary Telephone Number has been keyed in and the <ENTER> key is pressed, the system will
automatically advance to the Secondary Telephone Number.
The <A2> Lamp will flash to indicate the system is ready for the Secondary Telephone Number entry.
If a Secondary Telephone Number is already programmed, the digits of the current number will be displayed
sequentially via the Zone Lamps and the “0” Lamp. A chirp will sound each time the display steps to the next
digit.
When the end of the Telephone number is reached, 3 short beeps will sound to indicate there are no more
digits to display.
5. Program the Secondary Telephone number. (Optional)
The display will prompt for each digit to be entered via flashing Zone Lamps.
Enter the new Telephone number ... (Up to 15 digits), then press .
The digits are entered in the same manner as described for the Primary Telephone number.
If a mistake is made while keying in the Telephone number digits, press to clear all the digits entered
and start keying in the number again.
3 beeps will sound to confirm the new Telephone number has been programmed.
If the Telephone number was rejected, one long beep will sound to indicate a problem.
6. View the Primary Telephone number or Exit Telephone Number programming.
When the Secondary Telephone Number has been keyed in and the <ENTER> key is pressed, the system
will automatically return to the Primary Telephone Number entry and display the number sequentially as
described in Step 2.
To View or Change the Primary Telephone Number return to Step 2.
To Exit Telephone Number programming; Press .
To Next Page
Loading...
