19
Version 2.02 December-2002
4.5 TEST TRANSMISSION. NEXT 25
This operation will instruct the Control Module to send a test transmission to a central station or a
domestic telephone number.
Enter your PIN code; ... , then press , , .
When transmitting to a Central Station in Contact ID format, Event Code 602 is sent.
4.6 BATTERY TEST. NEXT 26
This operation instructs the Control Module to switch off the battery charger for 5 seconds so the
battery voltage can be tested.
Enter your PIN code; ... , then press , , .
If the battery is OK, the Terminal will beep 3 times at the end of the test period.
If the battery voltage is low, the Terminal will sound one long beep at the end of the test period and
you should contact your Installer/Maintenance Technician.
Note that the system can be programmed by the installer to do an automatic battery test every 8 hrs.
4.7 ANSWER PHONE. NEXT 27
This operation will cause the Control Module to answer an incoming telephone line call when
connection is required for remote programming.
IMPORTANT NOTE: THIS OPERATION IS ONLY TO BE USED WHEN INSTRUCTED TO DO SO
BY THE INSTALLER OR MAINTENANCE TECHNICIAN.
Enter your PIN code; ... , then press , , .
To Next Page
Loading...
Need help?
General
