Innovative Technology ITUT-400 - Before Use; How to Replace the Turntable Stylus (Needle)

5

BeforeUse

1.Chooseunitinstallationlocationcarefully.Avoidplacingitindirectsunlightorclosetoasource
of heat. Also avoid locations subject to vibrations and excessivedust, cold or moisture. Keep
awayfromsourcesthathum,suchastransformersormotors.
2.Donotopenthecabinetasthismightres
ultindamagetothecircuitryorelectricalshock.Ifa
foreignobjectshouldgetintotheset,contactyourdealer.
3. When removing the power plug from the wall outlet, always pull directly on the plug, never
pullthecord.
4.Donotattempttocleantheunitwithch
emicalsolventsasthismightdamagethefinish.Usea
clean,drycloth.
5.Keepthismanualinasafeplaceforfuturereference.



HowtoReplacetheTurntableStylus(Needle)

Removingoldstylus

1.Setascrewdriveratthetipofthestylusandpush
downinthedirection“A”.
2.Removethestylusbypullingitforwardanddown.


Installinganewstylus

1.Holdthetipofthestylusandinserttheotheredge
bypressinginthedirection“B”
.
2.Pushupinthedirection“C”untilitlocksatthetip.


