Inovance IS580 Series - Page 39

Chapter 3 Mechanical and Electrical Installation IS580 User Manual
- 38 -
3.8.4 Password Setting
The servo drive provides the user password protection function. The following figure shows how to set the
password to 1234.
Figure 3-27 Setting the password
F01500
PRG
Switchover
FP
PRG
Switchover
FP-00
0000
PRG
Return
PRG
Cancel
ENTER
Save
ENTER
ENTER
PRG
Return
FP-01
1234
Press /
Status parameter
(
Default display)
If there is a blinking digit, press
/ / to modify the digit.
3.8.5 Quick View of Function Codes
The IS580 provides two quick modes of viewing the required function codes.
•
You can dene a group and combine a maximum of 16 commonly used function codes into the group.
•
The IS580 automatically lists the modied function codes.
You can perform switchover amongst the function code display modes by pressing
QUICK
. The method of viewing
and modifying function codes in each mode is the same as the method of operating the operation panel described
above.
Figure 3-28 Switchover between function code display modes
uF1.03
15.00
User-defined mode
QUICK
cF0.03
QUICK
QUICK
uF1.07
uF4.03
···
cF0.08
cA4.03
···
(Defined function codes)
User-modified mode
(Modified function codes)
Status parameters
(Default display)
Press / to view
function codes in turn in
the specified range
Press ENTER to view the
parameter value.
The display on the right is only
an example of function codes.
.