Inovance MD280NT2.2GB - Page 140

MD280 User Manual Description of Function Codes
- 139 -
:KHQWKHFRXQWYDOXHUHDFKHVWKHVHW FRXQWYDOXH)WKH'2WHUPLQDODOORFDWHG
ZLWKIXQFWLRQ6HWFRXQWYDOXHUHDFKHG EHFRPHV217KHQWKHFRXQWHUFRQWLQXHVWKH
counting.
:KHQWKHFRXQWLQJYDOXHUHDFKHV WKHGHVLJQDWHGFRXQWLQJYDOXH)WKH'2WHUPLQDO
DOORFDWHGZLWKIXQFWLRQ'HVLJQDWHGFRXQWYDOXHUHDFKHGEHFRPHV217KHQWKHFRXQWHU
continues to count.
Figure 6-22 Reaching the set count value and designated count value
Count pulses input
Count pulses input
Designated count
v
alue reached output
Set count value
reached output
123
1110 12 20 2119
12
F7-09 11
F7-08 20
Function Code Parameter Name Setting Range Default
F7-10 /RDGVSHHGGLVSOD\FRHI¿FLHQW 0.0001–6.5000 1.0000
F7-11
Number of decimal places for load
speed display
0: 0 decimal place
1: 1 decimal place
2: 2 decimal places
3: 3 decimal places
1
F7-10 is used to adjust the relationship between the output frequency of the AC drive and
the load speed.
F7-11 is used to set the number of decimal places for load speed display. The following
JLYHVDQH[DPSOHWRH[SODLQKRZWRFDOFXODWHWKHORDGVSHHG
$VVXPHWKDW)/RDGVSHHG GLVSOD\FRHIILFLHQWLVDQG)LV GHFLPDO
SODFHV:KHQWKHUXQQLQJIUHTXHQF\RIWKH$&GULYHLV+]WKHORDGVSHHGLV[
 GLVSOD\RIGHFLPDOSODFHV
Function Code Parameter Name Setting Range Default
F7-12 Accumulative running time 0–65535 h -
It is used to display the accumulative running time of the AC drive. After the accumulative
running time reaches the value set in F5-12, the corresponding terminal becomes ON.
You can clear the record of this parameter by setting FP-01.
efesotomasyon.com