Inovance MD380-5T5.5GB - Page 131

Function Code Table
MD380 User Manual
- 130 -
)unction
Code
Parameter Name
Setting Range
Default Property
A7-01
Selection of control mode of
the output terminals on the
control board
8QLWVGLJLW)05)0XVHGDV
digital output)
0 ƾ
0: Controlled by the AC drive
1: Controlled by the user
programmable card
7HQVGLJLWUHOD\7$7%7&
Same as unit's digit
Hundred's digit: DO1
Same as unit's digit
7KRXVDQGVGLJLW)05)0XVHG
as pulse output)
Same as unit's digit
Ten thousand's digit: AO1
Same as unit's digit
A7-02
AI/AO function selection of
the user programmable card
0: AI3 (voltage input), AO2
(voltage output)
1: AI3 (voltage input), AO2
(current output)
2: AI3 (current input), AO2
(voltage output)
3: AI3 (current input), AO2
(current output)
4: AI3 (PTC input), AO2 (voltage
output)
5: AI3 (PTC input), AO2 (current
output)
6: AI3 (PTC100 input), AO2
(voltage output)
7: AI3 (PTC100 input), AO2
(current output)
0 ƾ
A7-03 )MP
output
0.0%–100.0%
0.0% ƿ
A7-04 AO1 output
0.0%–100.0%
0.0% ƿ
A7-05 Digital output
%LQDU\VHWWLQJ
8QLWVGLJLW)05
Ten's digit: Relay1
Hundred's digit: DO
1 ƿ
A7-06
)requency setting through
the user programmable card
-100.00% to 100.00%
0.0% ƿ
A7-07
To
rque setting through the
user programmable card
-200.00% to 200.00%
0.0% ƿ
efesotomasyon.com