Inovance MD380-5T5.5GB - Page 89

Function Code Table
MD380 User Manual
- 88 -
)unction
Code
Parameter Name
Setting Range
Default Property
Group )4: Input Te
rminals
)4-00 DI1 function selection
0: No function
)RUZDUG581):'
2: Reverse RUN (REV)
3: Three-line control
)RUZDUG-2*)-2*
5: Reverse JOG (RJOG)
6: Terminal UP
1 ƾ
)4-01 DI2 function selection
7: Terminal DOWN
8: Coast to stop
)DXOWUHVHW5(6(7
10: RUN pause
11: Normally open (NO) input of
external fault
12: Multi-reference terminal 1
13: Multi-reference terminal 2
4 ƾ
)4-02 DI3 function selection
14: Multi-reference terminal 3
15: Multi-reference terminal 4
16: Terminal 1 for acceleration/
deceleration time selection
17: Terminal 2 for acceleration/
deceleration time selection
9 ƾ
)4-03 DI4 function selection
)UHTXHQF\VRXUFHVZLWFKRYHU
19: UP and DOWN setting clear
(terminal, operation panel)
20: Command source switchover
terminal 1
21: Acceleration/Deceleration
prohibited
22: PID pause
23: PLC status reset
24: Swing pause
25: Counter input
26: Counter reset
12 ƾ
)4-04 DI5 function selection
27: Length count input
28: Length reset
29: Torque control prohibited
13 ƾ
efesotomasyon.com