Inovance MD380-5T5.5GB - Page 93

Function Code Table
MD380 User Manual
- 92 -
)unction
Code
Parameter Name
Setting Range
Default Property
)4-38 DI valid mode selection 1
Thousand's digit (DI4 valid mode)
00000 ƾ
0, 1 (same as DI1)
Ten thousand's digit (DI5 valid
mode)
0, 1 (same as DI1)
)4-39 DI valid mode selection 2
Unit's digit (DI6 valid mode)
00000 ƾ
0, 1 (same as DI1)
Ten's digit (DI7 valid mode)
0, 1 (same as DI1)
Hundred's digit (DI8 state)
0, 1 (same as DI1)
Thousand's digit (DI9 valid mode)
0, 1 (same as DI1)
Ten thousand's digit (DI10 valid
mode)
0, 1 (same as DI1)
)4-40 AI2 input signal selection
0: Vo
ltage signal
1: Current signal
0 ƾ
Group )5: Output Te
rminals
)5-00 )M terminal output mode
3XOVHRXWSXW)03
6ZLWFKVLJQDORXWSXW)05
0 ƿ
)5-01
)MR function (open-
collector output terminal)
0: No output
1: AC drive running
)DXOWRXWSXWVWRS
)UHTXHQF\OHYHOGHWHFWLRQ
)'7RXWSXW
)UHTXHQF\UHDFKHG
=HURVSHHGUXQQLQJQRRXWSXW
at stop)
6: Motor overload pre-warning
7: AC drive overload pre-warning
8: Set count value reached
9: Designated count value
reached
10: Length reached
11: PLC cycle complete
12: Accumulative running time
reached
)UHTXHQF\OLPLWHG
2 ƿ
)5-02 Relay function (T/A-T/%-T/C) 2 ƿ
efesotomasyon.com