Inovance MD380-5T5.5GB - Page 96

MD380 User Manual Function Code Table
- 95 -
)unction
Code
Parameter Name
Setting Range
Default Property
)5-22 DO valid mode selection
8QLWVGLJLW)05YDOLGPRGH
00000 ƿ
0: Positive logic
1: Negative logic
Ten's digit (Relay 1 valid mode)
VDPHDV)05
Hundred's digit (Relay 2 valid
mode)
VDPHDV)05
Thousand's digit (DO1 valid
mode)
VDPHDV)05
Ten thousand's digit (DO2 valid
mode)
VDPHDV)05
)5-23 AO1 output signal selection
0: Voltage signal
1: Current signal
0 ƾ
Group )6: Start/Stop Control
)6-00 Start mode
0: Direct start
1: Rotational speed tracking
restart
2: Pre-excited start (asynchronous
motor)
0 ƿ
)6-01
Rotational speed tracking
mode
)URPIUHTXHQF\DWVWRS
)URP]HURVSHHG
)URPPD[LPXPIUHTXHQF\
0 ƾ
)6-02
Rotational speed tracking
speed
1–100
20 ƿ
)6-03 Startup frequency
0.00–10.00 Hz
0.00 Hz ƿ
)6-04
Startup frequency holding
time
0.0–100.0s
0.0s ƾ
)6-05
Startup DC braking current/
Pre-excited current
0%–100%
0% ƾ
)6-06
Startup DC braking time/
Pre-excited time
0.0–100.0s
0.0s ƾ
)6-07
Acceleration/Deceleration
mode
0: Linear acceleration/
deceleration
1: S-curve acceleration/
deceleration A
2: S-curve acceleration/
GHFHOHUDWLRQ%
0 ƾ
efesotomasyon.com