AC Drive Installation
‑16‑
4 AC Drive Installation
4.1 Pre-installation Inspection
Complete the following inspection items before installation.
Table 4–1 Pre‑inspection checklist
No. Item
Checked
1
The installation position is mechanically strong enough to bear the
weight of the AC drive.
□
2
The load‑bearing capacity of the ground and the environment meet
the installation requirements.
□
3
Sufficient clearance is reserved for heat dissipation, including for heat
dissipation of other devices in the cabinet.
□
4
The mounting bracket (if needed) is made of flame‑retardant
material.
□
5
If the application site is exposed to metal dust, install the drive in an
enclosed cabinet to isolate the drive from the metal dust. In this case,
the space inside the cabinet needs to be as large as possible.
□
6
Before installing the AC drive, install the bottom mounting bracket in
the cabinet and guide rails (optional), and prepare mounting beams
with holes reserved to fix the AC drive.
□
7
No flammables or explosives are placed near the drive.
□
4.2 Backplate Mounting
T1 models (three‑phase 380‑480 V: 0.37‑2.2 kW; single‑phase 200‑240 V: 0.37‑1.5 kW)
and T2 models (three‑phase 380‑480 V: 4‑5.5 kW; single‑phase 200‑240 V: 2.2 kW)
support backplate mounting.
PPrreerreeqquuiissiitteess
Before installation, check that the installation tools and environment have been pre‑
pared. For details, see "Mechanical Design" in the
MD600 Series Basic AC Drive Hard‑
ware Guide
. This section describes quick backplate mounting steps.
PPrroocceedduurree
1. Use a Phillips screwdriver to secure the M4x12 cross recessed pan head SEMS screw
(with the flat washer and spring washer) on the upper right side of the drive, as
shown in ①.
2. Repeat the previous step to fix the screw below the drive, as shown in ②.
To Next Page
Loading...
