Quick Operation
‑37‑
Set b5‑00 or b6‑00 to 0 to select digital setting as the frequency source. Then you can
set the frequency of the AC drive through the operating panel.
1. After power‑on, press
to enter the parameter setting interface. Press
, , and to locate b0‑03 (set channel selection) and set it to 0
(set channel 1). Then press
to confirm the settings.
2. Locate b5‑00 (main frequency source) and set it to 0 (digital setting).
3. Locate b5‑01 (main frequency digital setting) and set it to 20.00. That is, the output
frequency of set channel 1 to 20.00 Hz. The operating panel blinks 20.00.
The following table describes parameters related to the frequency source.
To Next Page
Loading...
