Inovance Monarch NICE-L-C-4037F

4 Commissioning Tools
-
139
-
In stop or running state, multiple state parameters can be displayed by pressing
on the operation panel to switch over every byte of FA-01 and FA-02.
■
Running state parameters
16 running state parameters are available in running state. Select whether to display
a parameter corresponding to every bit according to binary bits of FA-01 (Display in
running state).
■
Stop state parameters
12 stop state parameters are available in stop state. Select whether to display a pa-
rameter corresponding to every bit according to binary bits of FA-02 (Display in stop
state).
NOTE
◆
For details of states, refer to FA-01 and FA-02 in
6 Parameter Description
2 Parameter viewing
Press
PRG
and then / 󶍾
parameter groups.
After entering every level of menu, if a display bit blinks, it indicates that you can per-
󶍾 , , and 󶍾
󶍿
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
State parameter
(Default display)
(Return)
Level I menu
Level II menu
Level III menu
...
Cyclic process
(Return)
PRG
PRG
ENTER
ENTER
(Save)
ENTER
(Enter)
(Enter)
PRG
(Switchover)
PRG
ENTER
(Return)
(Enter)
PRG
(Return)
MF.KRUN
STOP
RES
QUICK
PRG ENTER
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
RUN
LOCAL/REMOT FWD/REV TUNE/TC
RPM
%
A VHz
󶙽Parameter viewing procedure
3 Parameter modi󶍾cation
After entering every level of menu, if a display bit blinks, it indicates that you can per-
󶍾 , , and .