6 Parameter Description
-
182
-
Group F0: Basic parameters
Function
Code
Name Setting Range Default Unit Property
F0-00 Control mode
0: Sensorless vector control
(SVC)
1: Closed-loop vector control
(CLVC)
2: Voltage/Frequency (V/F)
control
1 -
★
It is used to set the control mode of the system, as described in the following table.
Value
Control
mode
Function
Require
Encoder?
0
Sensorless
vector
control
(SVC)
It is applicable to:
Low-speed running during no-load commissioning
and fault judgment at inspection of the asynchronous
motor
Synchronous motor running on special conditions
(used only by professional engineers, not described in
this manual)
No
1
Closed-
loop
vector
control
(CLVC)
It is applicable to normal running in distance control. Yes
2
Voltage/
Frequency
(V/F)
control
It is applicable to equipment detection
(the ratio between the voltage and the frequency is
torque feature is poor).
No
Function
Code
Name Setting Range Default Unit Property
F0-01
Command source
selection
0: Operation panel
control
1: Distance control
1 -
★
It is used to set the source of running commands and running speed references, as
described in the following table.
Value
Running
Mode
Working Mode
Purpose Remarks
X Input Y Output
0
Operation
panel
control
Not
detect
X input
signals
Not output
(The relay
for the RUN
contactor will
output during
motor auto-
tuning.)
Used only
during motor
test or no-
load auto-
tuning
The controller is
operated by pressing
RUN and STOP on the
operation panel, and
the running speed is
set by F0-02
(Running speed under
operation panel
control)
To Next Page
Loading...
Need help?
General
