Inovance Monarch NICE-L-C-4037F

6 Parameter Description
-
258
-
Function
Code
Name Setting Range Default Unit Property
FP-05 Contract No. 2 0 to 65535 0 -
★
FP-06 Contract No. 1 0 to 65535 5555 -
★
FP-05 and FP-06 are used to set manufacturer contract No. Contract No. is used in the
HCB or door machine software requiring contract No. check. If the contract No. check
fails, the system cannot work properly.
Group Fr: Leveling adjustment parameters
Function
Code
Name Setting Range Default Unit Property
Fr-00 Leveling adjustment function
0: Invalid
1: Enabled
0 -
★
Fr-00 is used to set whether to enable the leveling adjustment function.
Function
Code
Name Setting Range Default Unit Property
Fr-01 Leveling adjustment record 1
00000 to 60060
30030 mm
★
Fr-02 Leveling adjustment record 2 30030 mm
★
to to to to to
Fr-20 Leveling adjustment record 20 30030 mm
★
These parameters are used to record the leveling adjustment values. Each parameter
󶍿󶍿
records are supported totally. The method of viewing the record is shown in the
󶍾
󶙽Viewing the leveling adjustment record
5
4 3
2
1
Floor 2
Floor 1
󶍾
󶍾󶍿󶍿
30, it is upward leveling adjustment; if the value is smaller than 30, it is downward
󶙓󶙓
adjustment. The maximum adjustment range is ±30 mm.
󶍿󶍿
󶍾