Safety Instructions
-
19
-
◆
Do not allow non-professionals to perform product installation, wiring, maintenance,
inspection or parts replacement.
◆
The installation, wiring, maintenance, inspection and parts replacement are intended to
be performed by professional personnel only.
◆
Installation personnel must be familiar with product installation requirements and rele-
vant technical materials.
◆
If you need to install transformer or other strong electromagnetic interference equipment,
install shielding device at the same time to avoid product malfunction.
Wiring
◆
Do not allow non-professionals to perform product installation, wiring, maintenance,
inspection or parts replacement.
◆
Never perform wiring at power-on. Failure to comply may result in electric shock.
◆
-
-
al voltage can discharge safely.
◆
Make sure that the equipment is reliably grounded. Failure to comply may result in electric
shock.
◆
Following the proper electrostatic discharge (ESD) procedures, and wear an anti-static
wrist strap to perform wiring. Failure to comply may result in damage to the equipment or
the internal circuit the product.
◆
Never connect the power cable with the product output terminals (U, V, W.). Failure to
◆
When connecting driving equipment with the motor, make sure the phase sequence of the
drive and motor are consistent to prevent motor reverse rotation.
◆
The cable used in wiring must conform to the wire diameter and shielding requirements,
the shielding layer of the shielded cable must be reliably grounded at one end.
◆
After wiring, make sure there are no fallen screws or exposed wire inside the cabinet or
product.
Power-on
◆
Before power-on, make sure that the equipment or products are intact, all wiring are safe-
ly connected, and the motor device allows a restart.
◆
Before power-on, check if the power supply meets the equipment requirements, avoid
◆
At power-on, equipment or product may start running abruptly, keep away from mechani-
cal device.
◆
After power-on, never open the cabinet door or the protective shell to avoid electric shock.
◆
Never touch any terminals at power-on to avoid electric shock.
◆
Never dismantle the equipment or remove any parts from the equipment at power-on to
avoid electric shock.
To Next Page
Loading...