Keypad
‑61‑
Display
Name
Applicable
Occasion
Meaning
Error
(wrong
password)
The user
password
(H02.30) is
activated and
the password
entered is
wrong.
A wrong password is entered. You
need to enter the password
again.
TunE
Auto‑tuning
with one‑key
enabled
The function of auto‑tuning with
one‑key is in progress.
FAIL
Auto‑tuning
with one‑key
enabled
The function of auto‑tuning with
one‑key fails.
Fault Display
● The keypad can be used to display present or previous fault and warning codes.
For analysis and solutions to the faults and warnings, see Chapter
"Troubleshooting".
● When a fault or warning occurs, the keypad displays the corresponding fault or
warning code immediately. When multiple faults or warnings occur, the keypad
displays the fault code of the highest fault level.
● You can select the previous fault/warning to be viewed through H0b.33 and view
the code of the selected fault/warning in H0b.34.
● You can clear the latest 10 faults or warnings saved in the servo drive by setting
H02.31 to 2.
For example, "E941.0" is displayed as following:
Display
Name
Description
E941.0
Warning code
E: A fault or warning occurs
on the servo drive.
941.0: Warning code
Monitored value display
● Group H0B: Displays parameters used to monitor the operating state of the servo
drive.
● Set H02.32 (Default keypad display) properly. After the motor operates normally,
the keypad switches from status display to parameter display. The parameter
group number is H0b and the offset within the group is the setpoint of H02.32.
To Next Page
Loading...
