Keypad
‑71‑
Figure 5‑12 Display H0b.05 when all DO are "active high"
■ Exit
The forced DO signal function is not retentive upon power‑off. Normal DOs
apply after restart, or you can set H0d.17 to 0 (No operation) to return to the
normal DO mode.
● Bus control forced DO function
After this function is enabled, all DO signal levels are controlled by 60FE.01h
(Physical output) and are unrelated to the internal DO signal status.
If the motor is used in vertical motion, when the brake output signal is set to
Enabled, the brake will open and the load may fall. Take protective measures on
the machine to prevent the risk of falling.
■ Operating process
To Next Page
Loading...
