Keypad
‑74‑
Figure 5‑15 Procedure for setting the user password
To change the user password, input current password first to authorize the access
to parameter setting. Next, enter H02.30 again to set a new password based on the
procedure shown in the preceding figure.
Note
If the last bit does not blink, the access to parameters is password protected. If the last bit
blinks, password is not needed or the password entered is correct.
● Canceling the user password
Enter the set user password, and set H02.30 to "00000" to cancel the user
password.
To Next Page
Loading...
