31
INOVANCE TECHNOLGY EUROPE GmbH
SV660N Startup Procedure_EN_v1.4_20220826.docx
The following image shows the InoProShop EtherCAT Master configuration. The EtherCAT setting allows you to
change the "Sync Offset" value to change the position of IRQ with respect to the SYNC signal.
The distributed clock is used in applications that require very high synchronization between slaves. All slave
clocks are aligned with the same time reference and generate synchronous events within each slave. The
interruption
For good synchronization, the SYNC signal that triggers a process data update must always follow the receipt of
the frame carrying new data values. However, the transmission time of the frame may fluctuate depending on
the implementation of the master, and therefore the frame carrying new output data may overlap with the
SYNC signal.
To Next Page
Loading...
