11
5.1 Surround Sound Receiver
www.insigniaproducts.com
Connecting headphones
To connect headphones:
1 Plug headphones into the PHONES jack on the
front of your receiver.
2 Press SPEAKER on the front of your receiver to
turn off the connected speakers.
Connecting speakers
Be sure to connect speakers firmly and correctly
according to the channel (left and right) and the
polarity (+ and -). If the connections are faulty, no
sound will be heard from the speakers, and if the
polarity of the speaker connection is incorrect, the
sound will be unnatural and lack bass. For
information about speaker placement, see “Placing
the speakers” on page 12.
After installing the speakers, first adjust the speaker
settings according to your environment and
speaker layout. (For more information see “Setting
the listening environment (ROOM EQ)” on page 16,
“Adjusting the speakers” on page 13, and “
Connecting speaker wires
To connect speaker wires:
1 Strip away approximately 3/8 inch (10 mm) of
wire insulation, then twist the wire ends tight.
2 Loosen the speaker jack cap by turning it
counterclockwise.
Warning
Do not set the volume too high when using
headphones. You can damage your hearing.
Note
When listening to a DTS or Dolby Digital program
source with the headphones are plugged in and the
speakers are turned off, your receiver enters
two-channel downmix mode automatically.
Caution
• Make sure that you use speakers with an
impedance of 6 ~ 16 ohms.
• Do not let the bare speaker wires touch each
other or any metal part on your receiver. This
could damage your receiver or the speakers.
• Never touch the speaker jacks when the power
cord is connect to a power outlet. This could
cause an electric shock.
Front leftFront right
Center
Surround right Surround left
To Next Page
Loading...
