13
5.1 Surround Sound Receiver
www.insigniaproducts.com
• We recommend installing the surround back
speaker(s) at a slightly downward facing angle.
This effectively prevents the surround back
channel signals from reflecting off the TV or
screen at the front center, resulting in interference
and making the sense of movement from the
front to the back less sharp.
Subwoofer
• Place a subwoofer anywhere in the front of the
main listening position.
Connecting an IR receiver
If your receiver is located inside a closed cabinet or
shelving unit, or you want to control this receiver in
another zone, you can use an optional IR RECEIVER.
Connect the IR receiver to the IR IN jack. For more
information on connecting the IR receiver, see the
operating instructions that came with the IR
receiver.
Adjusting the speakers
Selecting speaker type
If you used the SET ROOM EQ feature to set up the
speakers, you do not need to complete this task.
To select speaker type:
1 Press SETUP. The OSD opens.
2 Press TUNE or TUNE to select SPEAKER
SETUP, then press ENTER/MEMO. The SPEAKER
SETUP screen opens.
3 Press TUNE or TUNE to select SPEAKER
SETTING, then press ENTER/MEMO. The
SPEAKER SETTING screen opens.
4 Press TUNE or TUNE to select a speaker,
then press PRESET or PRESET to select the
speaker type. Depending on your speaker type,
you can select one of the following:
• Front, Center, Surround, and Surround Back
speakers:
• LARGE—Select this when connecting
speakers that can fully reproduce sounds
below crossover frequency.
• SMALL—Select this when connecting
speakers that cannot fully reproduce
sounds below crossover frequency. When
SMALL is selected, sounds below
crossover frequency are sent to the
subwoofer or speakers which are set to
LARGE (when no subwoofer is connected).
• NO—Select this when no speaker is
connected. When this is selected, sounds
are sent to the speakers which are not set
to NO.
• Surround back speakers:
• x2/x1— Select the number of speakers
connected to the SURROUND BACK
PRE OUT channels.
• Subwoofer:
• YES—Select this to output LFE signals and
bass frequencies from speakers set to
SMALL to the subwoofer.
• NO—Select this when no subwoofer is
connected. The bass frequencies are
output from other speakers.
Notes
• When using a conventional TV, use only
magnetically shielded front left and right and
center speakers to avoid interference with the
TV picture.
• To obtain the best surround effects, all speakers
except the subwoofer should be full range
speakers.
Note
Remote operation may become unreliable if the IR
receiver is exposed to strong light such as direct
sunlight or inverted fluorescent light.
Surround speaker
Surround back
speaker
Point down
slightly
23.6 ~ 35.4 inches
(60 ~ 90 cm)
SETUP MENU
SET ROOM EQ
SPEAKER SETUP
COMPONENT IN SETUP
TONE CONTROL
LANGUAGE
RETURN
ENGLISH
ON
SPEAKER SETUP
SPEAKER SETTING
CROSSOVER FREQUENCY
CHANNEL LEVEL
SPEAKER DISTANCE
SPEAKER SETTING
FRONT
CENTER
SURR
SURR. BACK
SUBWOOFER
LARGE
[ LARGE ]
[ LARGE ]
[ NO ]
[ YES ]
RETURN
To Next Page
Loading...
