5
5.1 Surround Sound Receiver
www.insigniaproducts.com
Remote control
Using the remote control
Installing remote control batteries
To install remote control batteries:
1 Remove the battery compartment cover.
2 Insert two AAA batteries into the battery
compartment. Make sure that the + and –
symbols on the batteries match the + and –
symbols inside the battery compartment.
3 Replace the cover.
# Item Description
POWER ON
When in standby mode, press to enter operating
mode.
Input selector
Press these buttons to select an input source. For more
information, see “Selecting the input source” on
page 17.
Numbers
Press to select a preset station.
SLEEP
Press to set the sleep time. The sleep timer will
automatically turn off your receiver after a preset time.
You can select 30 minutes, 60 minutes, 90 minutes,
or OFF.
SETUP
Press to open the on-screen display (OSD). For more
information, see “Using the on-screen display (OSD)”
on page 20.
TUNE / TUNE
Press to select a the radio station. Press and hold for
more than 0.5 seconds to search for the next or
previous station with a good signal.
SOUND PARAMETER
Press to select a sound parameter you want to adjust.
For more information, see “Adjusting sound
parameters” on page 19.
SURROUND /
SURROUND
Press to select a surround mode.
In menu mode, press to select an option.
STEREO Press to select stereo (2-channel downmix) mode.
BASS+ / BASS– Press to increase or decrease the bass.
1
2
3
4
5
6
7
8
9
10
LED indicator Lights when you press a button.
STANDBY Press to put your receiver in standby mode.
D.INPUTS
Press to select the audio input. For more information,
see “Selecting the input source” on page 17.
DIMMER
Press to adjust the brightness of the display. You can
select ON, dim, dimmer, or OFF.
DISPLAY
Press to change the status information on the display.
You can view information for the surround mode,
volume, or input source.
ENTER/MEMO Press to confirm selections.
PRESET / PRESET
Press to select a preset radio station.
In menu mode, press to adjust an option.
RETURN In menu mode, press to return to a previous menu.
MUTE
Press to mute the sound. Press again to restore the
sound.
VOL+ /VOL– Press to increase or decrease the master volume.
CH LEVEL
Press to select a channel level you want to adjust, then
press CH LEVEL + or CH LEVEL – to adjust the
channel. For more information, see “Adjusting a
channel level” on page 21.
CH LEVEL + / CH LEVEL –
Press to increase or decrease the output from a
selected channel. For more information, see
“Adjusting a channel level” on page 21.
TREBLE+ / TREBLE– Press to increase or decrease the treble.
Notes
• Remove the batteries when you do not plan to
use the remote control for a long period of time.
• Do not use the rechargeable batteries
(Ni-Cd type).
# Item Description
11
12
13
14
15
16
17
18
19
20
21
22
23
To Next Page
Loading...
