Instron DX Series - Chapter 4 Parts Replacement; Introduction

51
Chapter 4
Parts Replacement
• Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
• Replacement of fuses. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52
• Replacement or repair of load cells. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53
Introduction
DX systems require minimal parts replacement. If a part does require replacement, only the following
parts can or should be replaced by the customer:
• Fuses
All other parts replacement should be done by an Instron service engineer. For assistance with
replacement of any part, contact your local Instron Services department as directed on page 13.