Chapter 1: Introduction
12 M47-17028-EN
Frame configuration options
Frames can be configured with a variety of options. These options include:
• Crosshead variations:
• G1-style crossheads - Closed-front crossheads with manually operated grip assemblies for
tension testing
• G7-style crossheads - Open-front crossheads with hydraulically operated grip assemblies for
tension testing
• G8-style crosshead - Compression only frame with bolt pattern to accept compression fixtures
• Test opening variations:
• E1 - Standard tension opening
• E2 - Increase tension test space by: 610 mm (24 in) for 300DX frames, 406.4 mm (16 in) for
600DX frames
The configuration options selected for your frame are identified in the complete model number of the
frame. The complete model number is defined as:
{Capacity (in kN)}{Model family}-{Controller}{Crosshead style option}{Test opening option}
Some examples would be:
300DX-V1-G1-E1, 300DX-V1-G7-E1, 600DX-V1-G1-E1, 600DX-V1-G8
It is very important to be aware of and understand the configuration of your frame as you perform various
operations and procedures so that they can be performed correctly - the complete model number (in
whole or in part) is used throughout this manual to identify specifications and procedures appropriate for
your frame configuration. Knowing the complete model number of your frame is critical. To determine
the complete model number (and thus configuration) of your frame, refer to one of the following:
• The frame serial tag (see “System identification” on page 12)
• The Instron quote
Testing accessories
Testing accessories are purchased separately from the frame. Testing accessories either provide a
means to secure the specimen in the test space or provide additional functionality to the frame.
Instructions on the installation, use and maintenance of Instron testing accessories are provided
separately with each testing accessory. A variety of testing accessories are available. Contact your
Instron Sales Representative for more information.
System identification
Your system has been given a unique serial number for system identification. This serial number can be
found on the serial tag located on the rear of the frame (i.e. the frame serial tag).
The frame serial tag includes other important system information, including information on your frame’s
configuration. Frame configuration information can also be found on your Instron quote. Refer to “Frame
configuration options” on page 12 for explanation of frame configuration.
To Next Page
Loading...
Need help?
General
