141
Controlling Other Components—Continued
5
Use the Up and Down [q]/[w] but-
tons to select category, and then
press [Enter].
The brand name input panel appears.
6
Use the arrow [q]/[w]/[e]/[r] but-
tons to select a character, and
then press [Enter].
Repeat this step from the 1st character
to the 3rd character of the brand name.
When you have entered the 3rd charac-
ter, select “Search” and press [Enter].
After searching, a list of the brand
name appears.
If the brand name is not found:
Use the Right [r] button to select
“Not Listed”, and then press [Enter].
The brand name input panel appears.
7
Use the Up and Down [q]/[w] but-
tons to select brand, and then
press [Enter].
After searching is completed, a mes-
sage for remote control code transfer
will appear.
ABCDEFGH I J KLM
NOPQRS TUVWX YZ
1234567890 &@
–
Space
Back Space
Search
8–1. Remote Mode Setup
TV
Category
Brand
TV
Not Listed
Sonawa
Sonber
Songba
Sonic
Soniko
8–1. Remote Mode Setup
TV
Category
Brand
TV
SON
8–1. Remote Mode Setup
TV
Category
Brand
TV
XXXXX
OK
Now we are ready to transfer data to Remote
Please hold remote so that it is facing the receiver.
Use Enter button of your remote to activate “OK”.
Ready?
To use the remote controller, point it at
the AV controller’s remote control sen-
sor, as shown below.
On the remote controller press the
[Enter] button.
When the transfer is successful, the fol-
lowing screen appears. Try it.
* When category other than TV have been
selected, the content is different.
8
If you can control component,
press the [Receiver] button, use
the Up and Down [q]/[w] buttons
to select “Works”, and then
press [Enter].
The “Remote Mode Setup” menu
appears.
If you cannot control component,
use the Up and Down [q]/[w] but-
tons to select “Doesn’t work (try
next Code)” and press [Enter].
The next code is appear.
9
When you’ve finished, press the
[Setup] button.
The setup menu closes.
15
15
AV controller
Approx.
16ft. (5 m)
Incoming sensor
Transmitter
15° off center
(Left/Right/Up/Down)
Category
Brand
TV
XXXXX
8–1. Remote Mode Setup
TV
Wait
8–1. Remote Mode Setup
TV
Category
Brand
TV
XXXXX
Works
Doesn’t work (try next Code)
1. Push remote Mode [TV].
2. Push some key to see if the TV responds.
3. Push remote Mode [Receiver].
4. Choose “Works” or “Doesn’t work”.
To Next Page
Loading...
Need help?
General
