Integra DHC-80.1

53
First Time Setup—Continued
Note:
This procedure can also be performed on the AV control-
ler by using its [Setup] button, arrow buttons, and [Enter]
button.
If you connect an u-capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE IN/
OUT jacks, or connect an RI Dock to the GAME IN or
VCR/DVR IN jacks, for u to work properly, you must
change this setting.
This setting can only be changed on the AV controller.
Notes:
• DOCK can be selected for the TV/Tape or Game or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before
using the AV controller’s remote controller for the first
time (see page 142).
3
Use the Up and Down [q]/[w] but-
tons to select “3. Tuner”, and
then press [Enter].
The “Tuner” menu appears.
(North American models)
(Australian models)
4
Use the Left and Right [e]/[r]
buttons to select:
(North American models)
200kHz/10kHz:
Select if 200 kHz/10 kHz steps are
used in your area.
50kHz/9kHz:
Select if 50 kHz/9 kHz steps are
used in your area.
(Australian models)
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
5
Press the [Setup] button.
The setup menu closes.
Changing the Input Display
7–3. Tuner
FM/AM Frequency Step
SAT Radio Mode
200kHz/10kHz
None
AM Frequency Step 9kHz
7–3. Tuner
1
Press the [TV/Tape], [Game] or
[VCR/DVR] input selector button
so that “TV/TAPE”, “GAME” or
“VCR/DVR” appears on the dis-
play.
2
Press and hold down the [TV/
Tape], [Game] or [VCR/DVR]
input selector button (about 3
seconds) to change the setting.
Repeat this step to select MD, CDR, or
DOCK.
For the TV/Tape input selector, the
setting changes in this order:
For the Game input selector, the setting
changes in this order:
GAME ↔ DOCK
For the VCR/DVR input selector, the
setting changes in this order:
VCR/DVR
↔ DOCK
Game TV/Tape
VCR/DVR
or
or
or
or
(3 seconds)
TV/TAPE → MD → CDR
DOCK
→
→