143
Controlling Other Components—Continued
Integra/Onkyo components that are connected via u
are controlled by pointing the remote controller at the
AV controller, not the component. This allows you to
control components that are out of view, in a rack, for
example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that’s not con-
nected via u, use the following remote control codes:
• [DVD/BD] button
30627: Integra/Onkyo DVD player without u
(default)
• [CD] button
71817:
Integra/Onkyo CD player without
u
(default)
•[TV] button
11807: TV with (default)
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, use the
following remote control codes:
32900: Integra/Onkyo BD player
32901: Integra/Onkyo HD DVD player
70868: Onkyo MD recorder
71323: Onkyo CD recorder
81993: Onkyo RI Dock with u
Note:
If you connect an u-capable Onkyo RI Dock to the
TV/TAPE, VCR/DVR, or GAME jacks, for u to work
properly, you must set the Input Display accordingly
(see page 53).
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Integra/
Onkyo Components Connected via
u
1
Make sure the Integra/Onkyo component
is connected with an u cable and an ana-
log audio cable (RCA).
See page 40 for details.
2
Enter the appropriate remote control code
for the Remote Mode button.
• [DVD/BD] button
31612: Integra/Onkyo DVD player with u
•[CD] button
71327: Integra/Onkyo CD player with u
•[TV/Tape] button
42157: Onkyo cassette recorder with u
(default)
• [Port] button
82351: Onkyo Dock (default)
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV controller, and
operate the component.
Resetting Remote Mode Buttons
1
(3 seconds)
While holding down the Remote
Mode button that you want to
reset, press and hold down the
[Audio] button until the Remote
Mode button lights up (about 3
seconds).
2
Within 30 seconds, press the
Remote Mode button again.
The Remote Mode button flashes
twice, indicating that the button has
been reset.
Each of the Remote Mode buttons is
preprogrammed with a remote control
code. When a button is reset, its prepro-
grammed code is restored.
Note:
The learning command is also reset.
Resetting the Remote Controller
1
(3 seconds)
While holding down the
[Receiver] button, press and hold
down the [Audio] button until the
Receiver button lights up (about
3 seconds).
2
Within 30 seconds, press the
[Receiver] button again.
The Receiver button flashes twice, indi-
cating that the remote controller has
been reset.
To Next Page
Loading...
Need help?
General
