EasyManua.ls Logo

Integra DTR-6.8 - Adjusting the Volume for Zone 2

Integra DTR-6.8
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
113
Zone 2—Continued
Adjusting the Volume for Zone 2
To Mute Zone 2:
Press the remote controller’s [Zone 2] button, followed
by the [Muting] button. To unmute Zone 2, press the
remote controller’s [Zone 2] button again, followed by
the [Muting] button, or adjust the volume for Zone 2.
Notes:
Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it’s con-
nected to an analog input.
While Zone 2 is being used, listening modes that need
surround back speakers (i.e., Dolby Digital EX, DTS-
ES, and THX Select2 Cinema) are unavailable.
While Zone 2 is on, functions will not work.
You can’t select different radio stations for Zone 2 and
the main room. For example, if you have an FM sta-
tion for the main room, that station will also be used in
Zone 2.
Adjusting the Tone and Balance for Zone 2
You can adjust the bass, treble, and balance for Zone 2.
Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
Balance
You can adjust the balance of the left and right speakers
in Zone 2 in 2 dB steps, +10 dB to the right and +10 dB
to the left.
The balance cannot be adjusted when the Powered Zone
2 setting is set to Not Act (page 110) or the Zone 2 Out
setting is set to Fixed (page 111).
On the remote controller, press
the [Zone 2] button, and then use
the [Level–] and [Level+] buttons.
On the AV receiver, use the Zone
2 Level [ ]/[ ] buttons.
If your Zone 2 speakers are connected
to a receiver or integrated amp in Zone
2, use its volume control to adjust the
volume.
Zone 2 Level ,
Remote
controller
AV receiver
1
Press the [Zone 2] button, and
then press the [Tone] button
repeatedly to select Bass, Treble,
or Balance.
2
Use the Tone [+] / [–] buttons to
adjust.
1 2
DTR-6.8_En.book Page 113 Wednesday, June 20, 2007 4:16 PM

Table of Contents

Other manuals for Integra DTR-6.8

Related product manuals