Integra DTR-7.6 - HDMI Video Setup (DTR-7.6 Only)

41
First Time Setup —Continued
If you connect a video component to HDMI IN 1 or 2,
you must assign that input to an input selector. For exam-
ple, if you connect your DVD player to HDMI IN 1, you
must assign HDMI IN 1 to the DVD input selector.
Note:
When HDMI IN 1 or 2 is assigned to an input selector
here, the digital audio input for that selector is automat-
ically set to HDMI IN 1 or 2. See “Digital Audio Input
Setup” on page 43.
HDMI Video Setup (DTR-7.6 Only)
2
2, 3
1, 4
1
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “0.HDMI Video,”
and then press [Enter].
The HDMI Video menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and use the Left and Right
[ ]/[ ] buttons to select:
IN1: Select if the video component
is connected to HDMI IN 1.
IN2: Select if the video component
is connected to HDMI IN 2.
No: Select if you’re not using a
HDMI connection.
4
Press the [Setup] button.
Setup closes.
0.HDMI Video
------------------------
a.DVD :No
b.VIDEO1 :No
c.VIDEO2 :No
d.VIDEO3 :No
e.VIDEO4 :No
DTR-7.6,6.6.book Page 41 Monday, September 26, 2005 1:40 PM