68
Advanced Setup
—Continued
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “3. Speaker
Setup,” and then press [Enter].
The Speaker Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select “Speaker Dis-
tance,” and then press [Enter].
The Speaker Distance menu appears.
Note:
Speakers that you set to No or None on
the Speaker Config menu (page 66)
cannot be selected.
These settings are set automatically by the Automatic
Speaker Setup function (see page 38).
3-3.Speaker Distance
------------------------
a.Unit :feet
b.Left :12.0ft
c.Center :12.0ft
d.Right :12.0ft
e.Surround R : 7.0ft
f.SurrBack R : 7.0ft
g.SurrBack L : 7.0ft
h.Surround L : 7.0ft
i.Subwoofer :12.0ft
4
Use the Up and Down [ ]/[ ]
buttons to select “a. Unit,” and
then use the Left and Right
[ ]/[ ] buttons to select:
feet:
Select if you want to enter
distances in feet. Can be set
from 1 to 30 feet in 0.5-foot
steps.
meters:
Select if you want to enter
distances in meters. Can be
set from 0.3 to 9 meters in
0.15-meter steps.
5
Use the Up and Down [ ]/[ ]
buttons to select each speaker
and then use the Left and Right
[ ]/[ ] buttons to specify the
distance.
Specify the distance from the speaker
to your listening position.
6
Repeat step 5 for all speakers.
7
Press the [Setup] button.
Setup closes.
DTR-7.6,6.6.book Page 68 Monday, September 26, 2005 1:40 PM
To Next Page
Loading...
Need help?
General
