80
Zone 2—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV Receiver
Controlling Zone 2 with the Remote
Controller
Note:
•To control Zone 2, you must press the remote control-
ler’s [Zone 2] Remote Mode button first.
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [Zone 2]
button repeatedly.
Alternatively, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the Zone 2 indicator
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).
To select AM, FM, or XM (North
American model only), press the
[Tuner] input selector button repeat-
edly.
To select the same source as that of the
main room, press the [Zone 2] button
repeatedly until “Zone 2 Sel: Source”
appears.
2
To turn off Zone 2, press the
Zone 2 [Off] button.
1 2
1
Press the [Zone 2] Remote Mode
button, then point the remote
controller at the AV receiver and
press the [On] button.
Zone 2 turns on, and the ZONE 2 12V
TRIGGER OUT goes high (+12 V).
2
To select an input source for
Zone 2, press the [Zone 2]
Remote Mode button, followed by
an Input Selector button.
To select AM, FM, or XM, press the
[Tuner] Input Selector button repeat-
edly.
3
To turn off Zone 2, press the
[Zone 2] Remote Mode button,
followed by the [Standby] button.
Zone2
On
Standby
Level–,
Level+
Input
Selector
To Next Page
Loading...
