26 Intel
®
Server Board S5000PSL
Clearing the Password
If the user or administrator password(s) is lost or forgotten, moving the password clear
jumper into the “clear” position clears both passwords. The password clear jumper must
be restored to its original position before a new password(s) can be set.
1. Power down the system. Leave the AC power cord connected.
2. Open the chassis. See your chassis documentation for instructions on removing the
chassis cover.
3. Locate the Password Clear jumper block at board position J1D2. See Figure 7.
4. Move the jumper from the normal operation position, covering pins 1 and 2, to the
Password Clear position, covering pins 2 and 3, as shown by the diagram.
Figure 7. Password Clear Jumper in Clear Password Position
5. Power up the server and wait 10 seconds.
6. Power down the server.
7. Move the Password Clear jumper back to the original position, covering pins
1 and 2.
8. Close the chassis.
9. Power up the server.
AF000423
3
2
J1D2
Default
Clear
Password
PASSWRD CLR
To Next Page
Loading...
Need help?
General
