54 Intel
®
Server Board S5000PSL
• Verify your SAS or SATA drives are connected to the correct ports on the server
board and the chassis backplane. See your chassis documentation for details about
backplane connections.
• If using ATA drives, verify that the master/slave settings are set correctly. See your
drive documentation for details on setting the master/slave settings.
• If using a RAID configuration with an add-in RAID adapter, make sure the RAID
adapter is installed correctly.
Bootable CD-ROM Disk Is Not Detected
Check the following:
• Make sure the BIOS is configured to allow the CD-ROM to be the first bootable
device.
LED Information
The Intel
®
Server Board S5000PSL includes LEDs that can aid in troubleshooting your
system. For the location of the LEDs, see “Intel
®
Light-Guided Diagnostics” on page 9.
BIOS POST Beep Codes
The table below lists the POST error beep codes. Prior to system video initialization, the
BIOS uses these beep codes to inform users of error conditions. Please note that not all
error conditions are supported by BIOS beep codes.
Table 7. POST Error Beep Codes
Number of
Beeps
Reason for Beeps and Action to Take
1, 2, or 3 Memory error. Reseat the memory or replace the FBDIMMs with known
good modules.
4 - 7 or 9 - 11 Fatal error indicating a possible serious system problem. Remove all add-in
cards and re-start the system. If the error still occurs, contact your service
representative. If the beep codes are not generated after the add-in cards
are removed, insert the cards one at a time, booting the system between
each card addition, until the beeps again occur to reveal the malfunctioning
card.
8 Replace or reseat the system video add-in card. If on-board video is being
used, the server board may be faulty.
To Next Page
Loading...
Need help?
General
