Intel
®
Server Board S5000PSL 31
7. Make sure the clips at each end of the DIMM socket(s) are pushed outward to the
open position. See letter “A” in Figure 10.
8. Holding the FBDIMM by the edges, remove it from its anti-static package.
9. Position the FBDIMM above the socket. Align the notch on the bottom edge of the
FBDIMM with the key in the DIMM socket. The arrow for letter “B” in Figure 10
is pointing to the key in the socket.
10. Insert the bottom edge of the FBDIMM into the socket.
11. When the FBDIMM is inserted, push down on the top edge of the FBDIMM until
the retaining clips snap into place. See letter “C” in Figure 10.
12. Make sure the clips latch firmly in place. See letter “D” in Figure 10.
Figure 10. Installing FBDIMMs
13. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM
sockets. See the documentation that came with your chassis for instructions on
removing chassis components.
14. Replace the chassis cover and reconnect the AC power cord. See the documentation
that came with your chassis for instructions on installing the chassis cover.
A
C
D
B
TP000425
To Next Page
Loading...
Need help?
General
