23
4.16. Mounting the rods
Use quality threads with a section greater than 0.60 mm² as it has good durability, low electrical
resistance per meter and resistance to the mechanical tension required by stretching, in order to avoid
bellies and overhang that would cause breakage.
15 cm
Aluminum rod
Outdoor wall
Screw with
bushing 10
Indoor area to be
protected
Min. height 2.10 m
Mín. 20 cm
Insulator of
polypropylene
Mounting the rods
4.17. Programming
The electric fence has several programmable parameters, which makes it versatile and allows you to
congure its operation as needed.
These settings are stored in a special internal memory that maintains this information even when the
fence is disconnected from the mains and the battery is removed, thus avoiding the need for frequent
reprogramming.
In addition to conguring the operation of the fence, it is also possible to perform tests on the func-
tioning of the sensors.
Attention: all the following schedules must be carried out with the fence turned off.
To Next Page
Loading...