Intelbras ELC 5002 - Jumper Settings and Remote Manuals

25
4.22. Place the Power jumper (JP1) in the High position;
1. Press the C key. Remote and the Fence LED will light up. Press and hold the key for approximately
5 seconds until the Fence and Zone LEDs ash, indicating that the controls have been turned off.
4.23. XAC 2000 TX Remote Control User Manual
Technical specications
Activation 3 command buttons
Frequency 433.92 MHz
Modulation OK (on/off key)
Alimentation 12 Vdc battery
Homologation
(01)07896637613569
0237-09-0160
This equipment operates on a secondary basis, that is, it is not entitled to protection against harmful
interference, even from stations of the same type, and may not cause interference to systems operating
on a primary basis.
4.24. XAC 4000 Smart Control remote control user manual
Congratulations, you have just purchased a product with Intelbras quality and safety.
The remote control XAC 4000 Smart Control, has 3 independent buttons (channels), modern design
and powered by a single 3V Button type battery.
Technical specications
Activation
3 botões de comando
Frequency
433,92 MHz
Modulation
FSK/OOK
Alimentation
Bateria de 3 Vdc CR2032
Color Preto
Homologation
0408-12-0160
(01)07896637634403
This equipment operates on a secondary basis, that is, it is not entitled to protection against harmful
interference, even from stations of the same type, and may not cause interference to systems operating
on a primary basis.