27
4.30. To enable arming/disarming the fence
1. Place the Power jumper (JP1) in the High position;
2. Press and hold the Sector key for approximately 5 seconds and the On LED will be lit. After this time
the Fence and Zone LEDs will ash for approximately 3 seconds and then go out.
4.31. To disable fence arming/disarming
1. Place the Power jumper (JP1) in the High position;
2. Press and hold the Sector key for approximately 5 seconds. During this period the Enabled and Zone
LEDs will remain lit. Then the Fence LED will turn on for approximately 3 seconds and after that all
LEDs will go out except the Zone LED.
4.32. Learning the perimeter of the fence
After the fence is activated for the rst time, after total absence of power, the Activated LED will start
blinking. After 10 ashes of the Fence LED (10 seconds), the On LED will stop ashing, indicating that
learning is complete.
Note: whenever there is a need for maintenance, changing cables, insulators, pruning vegetation,
changing the position of the Energy jumper, etc., a new learning process must be carried out due to the
new conditions. Therefore, the central power supply (network and battery) must be completely removed
and connected again so that it can perform the learning process.
To Next Page
Loading...