Intellinet 525824 - AC ADVANCED WIRELESS SETTINGS

- 17 -
ACADVANCEDSETTINGS
ProtectionMode:ProtectionshouldbesettoAutoorOn.
Onlyifyouknowforcertainthatyournetworkconsistsonlyof
wirelessACclientsshouldyouconsiderdisablingthisoption,
asitcanincreasetheperformanceofyourconnectionseverso
slightly.
Standard:TheIntellinetAccessPointsupportsalltypesof
wirelessdevicesinthe5GHzrange.Thisparameterenablesor
disablessupportfora,nandacdevices.Yourlikelychoiceis
goingtobe11ac/an/aVHT,asitincludesallformsof5GHz
wirelesscommunications.IfyouknowforcertainthatnoIEEE
802.3aclientswilleverneedtoconnecttoyournetwork,you
mayenabletheoption11ac/anVHT.

BeaconInterval(ms):See2.4GAdvancedSettings.
DataBeaconRate(ms):See2.4GAdvancedSettings.
RTSThreshold:See2.4GAdvancedSettings.
BroadcastSSID:See2.4GAdvancedSettings.
WMM:See2.4GAdvancedSettings.
APIsolation:See2.4GAdvancedSettings.
ShortGI:See2.4GAdvancedSettings.
20/40MHzCoexist:See2.4GAdvancedSettings.

DFSSupport:DynamicFrequencySelection(DFS)isarequirementforradiosystemsoperatinginthe5GHzbandtobe
equippedwiththeabilitytoidentifyandtakeactiontoavoidotherradiotransmissionsthatareconsideredprimary‐use
ormission‐critical.Thesemission‐criticaldevicesarevariousflavorsofradarsystemsusedbyspecificindustrial,federal
civilianandmilitaryorganizations.Setthisvalueto‘enable’andselectyourregion,i.e.,FCCorCE/ETSI,andthensetthe
channelinthe5GACsettingsto‘Auto(DFS)’.

VHTBandWidth:Select80MHztobenefitfromthefulladvantageoftheincreasedWirelessACthroughput,butselect
20/40MHzinacrowdednetworkenvironmentwithmanywirelessnetworks,toreducethepossibilityofinterference.

VHTShortGI:See2.4GAdvancedSettings.



