Intercomp CS750 - Power;Batteries; Legal-for-Trade Sealing

CS750 User Manual
Rev E, April 2018
Page 27 of 31
Power/Batteries
Battery Replacement
On the right side panel, remove the two screws that hold the back plate secure. Slide
the plate out to access the batteries. Replace the cells with (4) standard alkaline "D"
batteries, paying special attention to polarity. Replace the panel.
Legal-for-Trade Sealing
Qualified Calibration Facilities:
1. On the left side of the CS750, replace the 2 front screws with the drilled screws
provided.
2. Thread a lead & wire seal through the 2 screws on the left side.
3. Crimp the lead seal tightly.
4. On the right side of the CS750, replace the 2 front screws with the drilled screws
provided.
5. Thread a lead & wire seal through the 2 screws on the right side.
6. Crimp the lead seal tightly.