During the entry and exit delay, beeps will sound every second. The beep rate will
increase during the last 10 seconds of the entry or exit delay.
When a door or window opens when the system is disarmed and the Chime
feature has been turned on and set to a beep sound, one or two beeps may occur
every time it opens. Note: The chime can be set to bell, siren, or voice—one beep
or two beeps.
A form of Chime where one beep is heard when a sensor such as a tilt sensor is
attached to an asset such a piece of art. Information displays under the Assets
icon.
Six beeps, repeated every minute. These beeps, and a flashing yellow
exclamation over the blue shield icon on the main screen, indicate some form of
system trouble (note building trouble). Some of the more common conditions for
trouble beeps include power failures, low battery, sensor supervision, and
communication trouble with the central monitoring station.
Press the Shield icon on the main screen to stop beeps for the current
condition for four hours (may be set to a different duration by the Installer). A new
condition will cause more beeps. Encountering more than one trouble condition is
very rare.
To permanently stop the trouble beeps from repeating, resolve the condition.
Contact the service provider for more information.
To Next Page
Loading...
